Mounting an SB16 or other Hatori two pc. Muffler

UPDATE at the bottom

This shows the parts from the underside of a Fury. The principle is the same on any model. Be sure the frame
is rigid at the mount point. We did this by inserting two spacers and bolting them between the frames. This made
the mount very rigid. Also make sure you use standoffs that allow the muffler to remain in a neutral position, not
twisted or turned.

If you use the optional Shadel mount with one standoff and a set screw, the brace between the frames is even more important.

UPDATE

We now have spacers the correct length. The parts you need to do this on a Fury are as follows:

• 1 - JH53 Standoffs (2 in a pack)
• 2 - MA106-78
• 2 - M3x30 bolts
• 10 - M3WL Large washers
• Some Loctite