| Reactor X2 Features and Specifications: * Never-shut-down circuitry ensures constant power delivery in any possible condition with system always reverting to power ON * Exclusive Voltage Bus selectable output setting, no setup required * Quick-charge cable, direct power to servos, redundant RX power, and fail-safe-on logic switch * Use on/off switch harness of any type, or power on with removable pin-switch jumper included * Triple redundant receiver power and direct current to CCPM Servo BusInput Voltage Supply: 7.2-8.4VOutput 1(CCPM/3Servo BUS): 6.0V, 6.8V or 8.4V (unregulated) selectable; 15A+Output 2(RX, Gyro, Tail Rotor): 5.2V; 5.0A On/Off Failsafe: Reactor failsafe to ON if switch failureCompatibility: JR, Spektrum, Futaba, Hitec, etc.Battery types supported: Li-Poly, Li-Ion, Ni-MH, Ni-CadFast charge capable: Included fast charge cableWeight: 56.5gBatt/Charge connector: Deans ultra plug styleAs the unfailing heart of your helicopter. The Reactor X2 generates noticeable servo power, which provides consistency and agility for both 3D and F3C flight. Providing power to the servos and receiver on dual power bus voltage regulators, the Reactor X2 is one of the first of its kind to provide split power output and servo bus technology to the R/C heli market.A lot is riding on the power system of any r/c heli, don't trust anything less than Reactor X2the old saying is true - you get what you pay for.New X2 FeaturesWe've added what customers wanted to the popular, proven, and high quality ReactorX regulator. * Three selectable voltage settings of the CCPM servo bus (regulated 6.0V, regulated 6.4V, NEW unregulated 8.4V) * Supports over 15 Amps of continuous output for use with any servos on the market.The preset CCPM voltages are: 6.0V regulated for all standard and digital servos. 6.8V regulated for high voltage type servos and brushless series servos. In addition the new X2 now allows full unregulated Li-Po voltage (8.4V at full charge) to pass directly to the servos for maximum voltage to HV type servos.Reactor X2 allows pilots to use HV servos on any type of receiver that normally would not allow direct Li-Po power supply. Certain Futaba, JR and other receivers do not permit direct Li-Po input voltage but can now be used with Reactor X2 by passing high voltage directly to the CCPM servos and a safe 5.2V to the receiver. |
